✅How to Dead Recover Jazz Wingle and Cloud Devices [R191j, MF673, MF25]✅

Learn how to recover dead Jazz Wingle and Cloud ZONG devices (R191j, MF673, MF25) using Qualcomm and USB drivers, test points, and 1-click fix tools. Step-by-step guide included.

---

Introduction

Is your Jazz Wingle or Cloud device not powering on or stuck in a dead state? Don’t worry — you're not alone. Many users experience this issue due to firmware corruption or improper flashing. In this post, we’ll guide you through a simple and effective dead recovery method that works on supported models such as Jazz Wingle R191j, Cloud Jazz MF673, and Cloud ZONG MF25.

---

✅ Supported Devices

This method is tested and verified for the following models:

1. Jazz Wingle R191j

2. Cloud Jazz MF673

3. Cloud ZONG MF25

---

🛠️ Tools and Files Required

Before we begin, make sure you have the following tools and drivers:

1. Qualcomm Driver

2. USB Driver

3. Android Driver

4. 900E Fix File

5. 9008 1-Click Fix File

Ensure all drivers are properly installed to prevent connection issues during the process.

---

📍 Step 1: Install All Necessary Drivers

1. Install Qualcomm Driver on your PC. This allows communication with your device in EDL (Emergency Download) mode.

2. Install USB and Android Drivers to ensure seamless recognition of the device by your computer.

💡 Tip: Restart your PC after driver installation for better compatibility.

---

🔧 Step 2: Enable Qualcomm Port Using Test Point

To detect your dead Jazz/Cloud device in Qualcomm mode, follow these steps:

1. Disassemble the device carefully.

2. Locate the Test Point on the PCB (Printed Circuit Board). It’s usually near the USB port or processor.

3. Short the Test Point using a metal tool (like tweezers) and plug the USB cable into your PC.

4. Your device should now show as Qualcomm HS-USB QDLoader 9008 in Device Manager.

⚠️ Important: Be careful while shorting the test point. Incorrect handling can damage your device.

---

⚙️ Step 3: Run 900E Fix File

1. Launch the 900E Fix Tool.

2. Click on Start/Run to begin the fix process.

3. Wait until the tool completes the operation. You’ll see a success message when done.

---

⚙️ Step 4: Run 9008 1-Click Fix File

1. Now open the 9008 1-Click Fix Tool.

2. Click Start to execute the final recovery.

3. The device will reboot automatically once the process completes.

---

✅ Final Result

Once the above steps are done:

1. Your Jazz Wingle or Cloud device should boot up normally.

2. If not, try repeating the process or check if the test point connection was stable.

---

💬 Conclusion

Recovering a dead Jazz Wingle or Cloud device is now simpler than ever. With the right tools and careful steps, you can bring your modem back to life without needing professional repair. This guide is ideal for technicians, enthusiasts, or anyone comfortable with basic hardware and software tools.

---

Keywords:

Dead Recover Jazz Wingle R191j, MF673 Cloud fix, MF25 Cloud ZONG recovery, Qualcomm 9008 fix, Test point enable, USB driver for ZONG

---

Was this guide helpful? Leave your questions or feedback in the comments below. Don’t forget to share with others facing the same issue!

File Password: pakistan